Vertical Edge 120 Specifications Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 146
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
- 3 -
DX-120 Installation Manual - Technical Manual Vol I REGULATIONS
FCC Regulations (continued)
FCC PART 68 INFORMATION
This equipment complies with Part 68 of the FCC Rules. A label, located on the exterior lower left side of the
cabinet, contains the FCC Registration Number(s) and Ringer Equivalence Number (REN).
Notify the local telephone company when you connect the equipment to the network and provide the information
shown in the following table:
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is
subject to state tariffs.
Should the equipment cause harm to the telephone network, the telephone company may disconnect your service
temporarily. If possible, they will notify you in advance. If advanced notice is not practical, they will notify you as
soon as possible. You will be informed of your right to file a complaint with the FCC. The telephone company may
make changes in its facilities, equipment, operations or procedures that could affect the proper functioning of your
equipment. If they do so, they will notify you in advance to give you an opportunity to maintain uninterrupted
telephone service. In addition, the telephone company may ask that you disconnect this equipment from the
network until the problem has been corrected or until you are sure that the equipment is not malfunctioning.
FCC Regulations (continued on next page)
Line Type
Service Order
Code*
Facilities Interface
Code
Ringer
Equivalence
Number*
Universal
Service Order
Code
Connector
Loop Start 9.0F 02LS2 See Equipment
Specification Sheet
RJ11
T1 Line 6.0Y 04DU9–1SN N/A RJ48C
ISDN (T1/PRI) Line 6.0Y 04DU9–1SN N/A RJ48C
NOTE
State tariffs do not permit ground start operation for KF registered
equipment (key system operation). Ground start operation is only
permitted for MF registered equipment (KTS/PBX hybrids with both
manual and pooled outgoing and incoming access to the network).
The system must
be configured for MF operation when using
ground start operation
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 145 146

Comments to this Manuals

No comments