Vertical IP8024 Installation Guide download pdf (Page 48)

Main Processing Board 4-6

Chapter 4: Board Installation

MBX IP Hardware & Installation Guide

Connector, Switch and LED Functions

The MPB is installed in the MPB Slot, providing various kinds of connectors and RJ21 jacks

(refer to the following table).

Connector, Modular Jack and Switch Functions

SW1 Functions

NOTE: Default is all OFF while delivering the board.

After all the boards are installed, and before programming the System, switch 1-1 should be

OFF and then power cycle OFF and ON to initialize the default System database. Once the

database has been initialized, switch 1-1 should be placed in the ON position to protect the User

database and to protect the features being programmed in Admin programming after the

System power up and initialization. Switch 1-2 should be placed in the ON position to feed

physically the Lithium Battery Voltage to SRAM/RTC to protect the User Database and System

Time/Date information, etc.

SWITCH/CONNECTOR, MJ FUNCTIONS REMARK

CN1 MPB100 or MPB300 Installation to the MB 120Pins

CN2, CN3 DSIU installation 20Pins

CN4, CN5 MODU Installation 20Pins, 6Pins

CN6 RS-232C Port Connection 9Pins

CN7 USB Connection (USB Memory Stick only) Host Mode Only

CN10 Emulator Debug port For R&D Test

CN11, CN12 CPLD Download for U11(for CN11), U37(for CN12) For R&D/Factory set

SW1 Admin Database Protection -

SW2 Watch-dog (OFF ; Enable, ON : Disable) Not Assembled at MP

SW3 System Reset Button -

RV1 Internal 32.768MHz “0” PPM Control For Factory set

PJ1 (Red) External MOH Connection -

PJ2 (Blue) External PAGE Connection -

MJ1 LAN Port -

MJ3 Alarm Sensor and External Relay Contact -

SWITCH FUNCTION OFF (DEFAULT) ON

1-1 Database Default at Power ON Enable Disable

1-2 Lithium Battery Back up ON/OFF for Memory and RTC Back up OFF Back up ON

Release 1.7

April 2012

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 159 160

No comments

Vertical IP8024 Installation Guide Page 48