Vertical IP8024 Installation Guide Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 160
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
Pre-Installation 3-8
Chapter 3: KSU Installation
MBX IP Hardware & Installation Guide
Power Supply Unit Installation
The Power Supply Unit (PSU) can be installed in the BKSU and the EKSU by the installer. Make
sure that the KSU is not plugged into an outlet. The PSU is located at the rear side of the KSU
and is capable of providing three kinds of power sources to the MB and MBE through the 20-pin
connector, CN6/CN7 (refer to the following Table).
AC Input Voltage and Fuse Rating
PSU Capacity
1. Insert the PSU along the guide rails on the rear side of the MBX IP system.
2. Slide and press PSU to the CN6 (PSU Connector) on MB and the CN7 (PSU
Connector) on MBE.
3. To affix securely, turn the 4 screws clockwise (as shown in illustration #2 below).
INPUT VOLTAGE CONNECTION FUSE RATINGS
100V AC – 240V AC CN6/CN7 on the MB/MBE 6.3A @ 250V
PSU TYPE +5V DC +27V DC +30V DC
PSU (SMPS) 10.0A 1A (Battery charge) 10A
Release 1.7
April 2012
Page view 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 159 160

Comments to this Manuals

No comments