Vertical SBX IP 320 Service Manual download pdf (Page 160)

ISDN Service 150

SBX IP 320 Features & Operation Guide

3. After entering the speed bin number, a CLI message using indication is displayed onto

speed dial digit position. It means that CLI can be entered pressing [CONF] button. If you

want to assign the CO for speed, it must be prior to pressing the [CONF] button.

4. Press the [HOLD/SAVE] button to store the speed dial number.

Conditions

• The CLI display works with about any type of CO service, if CO line is ISDN. But CLI

message wait only works with the DID/MSN CO service type of the ISDN line.

• The total number of CLI message wait is 500 (on a System basis).

• A Station without an LCD can not receive CLI message wait even though CLIP is set to

ON.

• CLI messages are saved against power failure.

• When the call is routed to a Ring Group, the CLI Message Wait pertains only to the first

member of the Ring Group.

• When the call is routed to a member of a UCD/ Circular/ Terminal station group, the CLI

Message Wait will be provided to the first ringing station.

• If the external party releases the line during the VMIB announcement, the CLI Message

Wait is not saved to any stations. If the external party releases the line during that time

that a station is ringing after the VMIB announcement, the CLI Message Wait will remain

at the first ringing station.

• Though the call is routed to station (A) that is forwarded to the another station (B), the

CLI Message Wait is provided to the original station (A). The basic rule for CLI Message

Wait follows the rule of the "Message Wait" feature.

• If there is no remaining buffer, the following warning message will be printed out

through RS-232C "WARNING: CLI MESSAGE WAITING BUFFER FULL".

• If the CLI number is programmed in the SPEED BIN No. Table with the "name" and the

CLI name display ADMIN programmed, then the name will be displayed in the LCD.

The CLI number and CLI user name is toggled by pressing the [CALLBK] button.

• When a user tries to delete all CLI messages at his station and some VMIB voice message

wait exist together with CLI message, the "all CLI delete" feature cannot be activated.

Because the priority of the message wait is as follows:

VMIB message wait ->CLI message wait -> VM Group message wait

CLI MSG USED

ENTER CO-BTN/DIGIT(001)

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 269 270

No comments

Vertical SBX IP 320 Service Manual Page 160