Vertical SBX IP 320 Service Manual download pdf (Page 25)

Call Control 15

SBX IP 320 Features & Operation Guide

Conditions

• While entering the account code, the current call is put on mute mode.

• The user may enter the account code before a call conversation is established.

Admin Programming

• Refer to the SBX IP 320 Installation Manual, SMDR Account Enter Code

(PGM 106 - Flex 7)

Authorization Code

If the Station is programmed to enter the authorization code by ADMIN programming, the

authorization code must be entered to access a CO line. An authorization code can be used for

SMDR, DISA account code.

Note: Personal authorization codes should be kept secure by the System Attendant and

individual Station Users to avoid fraudulent phone calls being made.

An authorization code is assigned as 3-11 digits as applicable; each station has a different

authorization code.

Operation

To access a CO line using an authorization code:

1. When attempting CO line access, a DND warning tone will be heard. Enter the

authorization code.

2. Press the # key (if 5 digits authorization code type is set according to PGM161-FLEX21,

the # key is not needed). If valid, the CO line will be connected; if not valid, an error tone

will be presented.

To register the authorization code on a Station:

1. Press the [TRANS/PGM] button.

2. Type 31.

3. Enter the authorization code, and press the # key (if 5 digits authorization code type is set

according to PGM161-FLEX21, the # key is not needed).

4. Press the [HOLD/SAVE] button to accept changes.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 269 270

No comments

Vertical SBX IP 320 Service Manual Page 25