Vertical Edge 120 Instruction Manual Page 38

  • Download
  • Add to my manuals
  • Print
  • Page
    / 504
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 37
SHORTCUTS THAT HELP YOU WORK FASTER DX-120 Programming Manual
- 30 -
Copying Baseline CO Line Setups
This is a programming aid feature. Once you have programmed one CO line for the baseline configuration settings,
you can copy those setting to other CO lines using this utility. Copying these setups requires two separate procedures
whether you program via PC-DBA or by DET:
You must:
A) Program the CO Line Setup to be copied
B) Copy the programmed CO Line Setup - Setups can be copied one line at a time or several lines at a time
COPYING BASELINE CO LINE SETUPS VIA PC-DBA
PROGRAM THE CO LINE SETUP TO BE COPIED
See “Section 5 - Programming C.O. Lines” for additional information about programming C.O. lines
COPY THE PROGRAMMED CO LINE SETUP
From the PC-DBA main screen:
1) Go to ProgrammingXSystem ApplicationXConfiguration Copy to display the Configuration Copy screen.
Copy the line(s) as needed:
Copy CO Lines One at a Time
2) Locate the Individual area under CO Line Copy.
3) Select the CO line directory number you want to use as a baseline from the dropdown list in the Source
DIR No. field.
• Valid directory numbers are 800 through 839.
• There is no default.
4) Select the CO line directory number into which you want to copy the baseline’s programming (800-839) in
the Destination DIR No. field.
5) Click Copy to make the specified copy.
• Enter any other CO line numbers as needed using the steps above.
• If needed, you can enter another source CO line directory number to copy from, and continue the
process for other CO lines.
Now... continue on to step 6 on the following page.
OR
Copy the Programmed CO Line Setup via PC-DBA (continued on next page)
Page view 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 503 504

Comments to this Manuals

No comments