Vertical SBX IP 320 Service Manual Page 182
- Page / 452
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Outgoing Call Access 1-168
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Station Speed Dialing (Digital and SLT Phones only)
Each station can store up to one hundred frequently dialed numbers to be used for speed
dialing.
CONDITIONS
• Up to 100 frequently used station numbers can be stored to Station Speed Bins (000-099).
Station numbers can consist of up to 24 digits including pauses, Flash commands,
pulse-to-tone switchover, and no-display characters (pause is automatically inserted after
a flash).
• A CPTU must be installed for dial tone detection (refer to the SBX Installation Guide).
• When storing Station Speed Dial numbers in a digital phone:
- the [DND/FWD] button can be used as Dial Tone Detect, if the CO Dial Tone Detect
feature is enabled, and stored as the first or second digit. In addition, the accessed
CO Line must be after the PBX mode.
- the FLASH button functions as Flash to PX (or PBX), if the accessed CO Line is
analog. If the accessed CO Line is ISDN line, and is stored as the first digit, FLASH
sends the remaining digits with envelope information in keypad facility IE, rather than
in the Calling Party Number IE.
• Station Speed Dial numbers are saved (in data protect mode) even if the system is
powered down (for example, during a power outage).
• There can be a maximum of twenty-four digits in a station Speed Dial number (including
special digits and function codes).
• An error tone sounds when an empty station Speed dial bin is dialed.
• If you select a CO Line before dialing a Speed Dial bin number, the selected CO Line
overrides the CO Line programmed for the Speed Dial bin number.
• A station name (max. 12 characters) can be stored, and will be displayed instead of the
user’s station number. Since the name is programmed in Speed Dial bin 000, this bin
cannot be used as a Station Speed Dial bin.
OPERATION / SETUP
To store Station Speed Dial numbers from a digital phone:
1. Press [TRANS/PGM], then press [SPEED].
2. Enter the Station Speed Dial bin (000-099) to be dialed.
3. Press the CO Line or Group button, if applicable.
Release 3.5
June 2010
- Release 3.5 1
- June 2010 1
- REVISION HISTORY 3
- Contents 5
- Contents TOC-2 6
- Contents TOC-3 7
- Contents TOC-4 8
- Contents TOC-5 9
- Contents TOC-6 10
- Appendix B VoIP Service 11
- Appendix C Voicemail Service 11
- Appendix E Quick Start Topics 12
- Contents TOC-9 13
- Basic System Features 15
- About This Guide 16
- Programming Guidelines 16
- 911 Feature 19
- Attendant Service 20
- Attendant Call & Queuing 21
- Attendant Forward 22
- Attendant Intrusion 22
- Attendant Override 23
- Attendant Recall 24
- LCD Date/Time Display 25
- Day/Night Service 26
- Outgoing Access 29
- DSS/BLF Consoles 30
- ICM Box Music 31
- Call Control 32
- Call Control 1-19 33
- Authorization Code 34
- Automatic Call Release 36
- Class Of Service (COS) 37
- Set Station COS 40
- System Speed Zone 43
- Call Handling 45
- Automatic Privacy 47
- Barge In 48
- Background Music (BGM) 49
- Call Screening 52
- Chime Bell 55
- CLI Display - SLT Feature 56
- CO Line Preset Forward 57
- Company Directory 58
- Setup Company Directory 59
- Call Handling 1-46 60
- Data Line Security 61
- Dialing Security 62
- Distinctive Ring Tone 62
- Do Not Disturb (DND) 63
- Do Not Disturb (One Time DND) 64
- Emergency Intrusion 66
- Extend CO-to-CO Connection 67
- Flex Buttons 69
- DEFAULT BUTTON CONFIGURATION 71
- Program CO Line 71
- Forced Hands-Free Mode 72
- Forced Trunk Disconnect 73
- Hot Desk 75
- In-Room Indication 77
- Intercom Tenancy Group 79
- Message Wait and Call Back 80
- Message Wait Indicator LEDs 81
- Call Handling 1-68 82
- Call Handling 1-70 84
- Call Handling 1-71 85
- Call Handling 1-72 86
- Mobile Extension 87
- Call Handling 1-75 89
- Music On Hold (MOH) 90
- On-Hook Dialing 92
- Call Handling 1-79 93
- Station Call Coverage 94
- Call Handling 1-81 95
- Call Handling 1-82 96
- Station Port Blocking 97
- Station User Programming 97
- Station Relocation 98
- Voice Over 99
- Call Handling 1-88 102
- Conference Calls 103
- Conference Room 104
- Conference Calls 1-92 106
- Paging Conference 107
- External Device Control 108
- Doorboxes 109
- Loud Bell 111
- Hunt Groups 112
- Hunt Groups 1-99 113
- Circular/Terminal Hunt Groups 115
- Hunt Groups 1-104 118
- UCD Group Report 120
- UCD Agent Report 120
- Set UCD Print Timer 121
- UCD Programming Codes 121
- Hunt Groups 1-110 124
- Hunt Groups 1-111 125
- Hunt Groups 1-112 126
- Hunt Groups 1-113 127
- Ring Hunt Groups 128
- Pick-Up Groups 131
- Hunt Group Name Service 131
- Incoming Call Pickup 133
- Incoming Call Pickup 1-120 134
- Direct Inward Dialing (DID) 139
- Select Automatic Speaker 140
- Set DID/DISA Destination 140
- Enable DID Call Wait 140
- Enable DID Restriction 140
- Incoming Call Pickup 1-131 145
- Preferred Line Answer (PLA) 148
- Ring Assignment 149
- Universal Night Answer (UNA) 150
- IP Phone Reroute Service 151
- ISDN Service 151
- Incoming CLI Service 152
- Outgoing CLI Service 153
- CLI Message Wait 155
- ISDN Service 1-142 156
- 03434507902 156
- DATE TIME CNTxx 156
- CLI Transit 158
- Linked Stations 160
- Linked-Pair Stations 162
- Outgoing Call Access 163
- Call Time Restriction 166
- CO Line Queuing 167
- Emergency Call Service 168
- Hot Line & Warm Line 168
- Least Cost Routing (LCR) 170
- Outgoing Call Access 1-157 171
- ADMIN PROGRAMMING 172
- Set LCR Attributes 172
- Memory Dialing 178
- Outgoing Call Access 1-167 181
- Outgoing Call Access 1-168 182
- Outgoing Call Access 1-169 183
- System Speed Dialing 184
- • Additional information: 185
- Enable Speed Dial Access 185
- Set System Speed Zone 185
- Paging 1-173 187
- Paging 1-174 188
- Pre-recorded (VMIB) Message 190
- Paging 1-177 191
- Rerouting 192
- Rerouting 1-181 195
- SLT Phone Call Forward 196
- Preset Call Forward 197
- Call Transfer 198
- Holding and Parking 201
- Rerouting 1-189 203
- Park and Page 204
- Directed Call Pick Up 205
- Group Call Pick Up 206
- Rerouting 1-193 207
- Software Upgrade 208
- Software Upgrade 1-195 209
- Modem Connection 210
- Software Upgrade 1-197 211
- Serial (COM port) 212
- Software Upgrade 1-199 213
- Access SMDR Local Code Table 216
- Enable ICM SMDR SAVE 216
- Enable ICM SMDR PRINT 216
- Set SLT DTMF RLS Timer 216
- Print-out - Lost Call 217
- Supplementary Service 220
- Traffic Analysis 220
- Attendant Reports 222
- Call Reports 223
- Traffic Analysis 1-210 224
- CO Reports 225
- Hardware (H/W) Unit Reports 226
- Traffic Analysis 1-213 227
- Other Programming Tables 228
- SMDR Account Group (PGM 124) 232
- Copy DSS Button (PGM 125) 233
- Station IP List (PGM 126) 233
- CO Line (PGM 140-146) 234
- Slot Base Program (PGM 155) 239
- System Data (PGM 160-184) 240
- System Attributes 2 (PGM 161) 241
- Music Assignment (PGM 171) 243
- PBX Access Code (PGM 172) 244
- Pulse Dial Ratio (PGM 176) 245
- SMDR Attributes (PGM 177) 245
- System Timers (PGM 180-184) 249
- System Timers 2 (PGM 181) 250
- System Timers 3 (PGM 182) 251
- DCOB Attribute (PGM 186-187) 252
- DCOB Attribute 2 (PGM 187) 253
- ISDN System Base Program 254
- Mobile Extension (PGM 236) 255
- Nation Specific (PGM 401-424) 256
- Initialization (PGM 450) 261
- Print Prot Database (PGM 451) 262
- Networking Services 263
- Attendant Call Service (CAS) 264
- Busy Lamp Field (BLF) 265
- Call Completion 266
- Call Offer 267
- CO Ring Assignment 269
- CO Transit - In 270
- CO Transit - Out 271
- Identification Service 273
- Network Call (Net Call) 275
- Network (Net) Call Forward 276
- Network Follow-Me Forward 277
- Network Conference 278
- Network Firewall Routing 279
- Network (Net) Transfer 279
- VOIP Networking 281
- For Both Systems A & B 283
- Networking Programming Tables 284
- VoIP Service 289
- Call by Routing Table 291
- Early H.245 292
- H.245 Tunneling 293
- Normal/Fast mode for H.323 293
- TOS for H.323 294
- Other VOIB Programming Codes 296
- Gatekeeper Setting (PGM 341) 298
- RSG/IP Attributes (PGM 382) 300
- IP Phone Attributes (PGM 386) 301
- RX gain tables for IP phone: 302
- TX gain tables for IP phone: 302
- SIP Programming (PGM 500-501) 303
- SIP Attributes II (PGM 501) 304
- Voicemail Service 305
- Appendix C: Voicemail Service 307
- Announce Only Mailbox 308
- Announcements 309
- Record User VM Greetings 311
- Calls to Voicemail 314
- Direct Transfer to VMIB 315
- Remote Control 318
- Mailbox Buttons 320
- Messages 322
- Reply to Messages 324
- Transfer Messages 325
- Outcall Notification 326
- Two-way Record 327
- Virtual Mailboxes 329
- Voice Mailbox COS 334
- Voice Mail Dialing Table 335
- Voice Mail Dialing Table C-32 336
- Appendix D 337
- Admin Programming Codes 338
- Admin Programming Codes D-4 340
- Admin Programming Codes D-5 341
- Feature Default Values 342
- - - (up to 12 digits) 366
- - On/Off Off 366
- - Flex 1-Flex 7 367
- - CO Line range 367
- - 00-63 371
- Attendant Programming Codes 380
- Flexible Numbering Plan 383
- Character Entry Chart 386
- Quick Start Topics 387
- Setting Up Voice Mail E-2 388
- Setting Up Voice Mail E-3 389
- Setting Up Voice Mail E-4 390
- Program Station Forwarding 391
- Setting Up Voice Mail E-6 392
- Creating A Ring Group 393
- Set the Ring Group Attributes 394
- 8. Click Update 396
- 11. Click Update 398
- Programming Via Phone 404
- Programming Via PCAdmin 405
- Networking Two SBX IP Systems 407
- System A Programming 408
- CO ISDN Attributes … Update 412
- DID Digit Mask #*** 413
- 7. Program VOIB Settings: 414
- System B Programming 419
- VOIP Card System A) … Update 428
- Type PSTN … Update 434
- Remote IP Phone Setup 436
- Remote IP Phone Setup E-52 438
- Remote IP Phone Setup E-53 439
- Remote IP Phone Setup E-54 440
- 11. Reset the KSU 441
- Remote IP Phone Setup E-56 442
- Remote IP Phone Setup E-59 445
- Remote IP Phone Setup E-60 446
Related products and manuals for IP phones Vertical SBX IP 320
IP phones Vertical Edge 120 Instruction Manual
(504 pages)
(504 pages)
(2 pages)
IP phones Vertical SBX IP 320 User Manual
(92 pages)
(92 pages)
IP phones Vertical SUMMIT IP User's Guide
(70 pages)
(70 pages)
IP phones Vertical Wave Phone User's Guide
(127 pages)
(127 pages)
IP phones Vertical IP8024 User's Guide
(62 pages)
(62 pages)
IP phones Vertical IP8024 Installation Guide
(160 pages)
(160 pages)
IP phones Vertical IP8012 User's Guide
(64 pages)
(64 pages)
IP phones Vertical SUMMIT IP Service Manual
(854 pages)
(854 pages)
IP phones Vertical Wave Phone User Manual
(20 pages)
(20 pages)
IP phones Vertical SUMMIT IP User's Guide
(124 pages)
(124 pages)
IP phones Vertical Wave Phone User's Guide
(150 pages)
(150 pages)
IP phones Vertical Edge 120 User Manual
(1 pages)
(1 pages)
IP phones Vertical SBX IP 320 Service Manual
(270 pages)
(270 pages)
IP phones Vertical SUMMIT IP User's Guide
(154 pages)
(154 pages)
IP phones Vertical Edge 480i User's Guide
(200 pages)
(200 pages)
IP phones Vertical Wave Phone User Manual
(19 pages)
(19 pages)
© 2020, manymanuals.com. All rights reserved. | 1.508 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals