Vertical SBX IP 320 Service Manual Page 79

  • Download
  • Add to my manuals
  • Print
  • Page
    / 452
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 78
Call Handling 1-65
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
OPERATION / SETUP
To assign the Intercom Signal mode:
1. Press [TRANS/PGM], then press 12.
The confirmation tone sounds.
2. Enter the signal mode type (1 = HF, 2 =TN, 3 = PV).
3. Press [HOLD/SAVE] to store the setting.
A confirmation tone is sounded.
Intercom Tenancy Group
A station can be assigned to any one of the Intercom Tenancy Groups. Each Intercom Tenancy
Group can be operated independently, and stations in the group can be assigned an individual
CO Group. A maximum of five Intercom Tenancy Groups can be assigned.
Each group can be assigned by the Attendant, and can be programmed to allow or deny calls
to other groups. Stations in a Group are allowed access to other stations based on the allowed
access of the calling Group.
When a call to another intercom Tenancy Group is allowed, CO line or station calls, as well as
pick-up and transfer features are activated.
CONDITIONS
When a call to another Intercom Tenancy Group is denied, call Pick-Up cannot be
activated.
Stations cannot have the same station numbers, regardless of whether or not they belong
to different Intercom Tenancy Groups.
Any station in the system can be the Attendant of an Intercom Tenancy Group. It is not
affected by Intercom Tenancy Group access.
When the Attendant of an Intercom Tenancy Group sets the Day/Night/Weekend mode, it
affects their assigned Intercom Tenancy Group only.
ADMIN PROGRAMMING
Set Intercom Group Number
ICM Group (Intercom Tenancy Group) -- selects the intercom
Tenancy Group (1-5), to which this station belongs.
PGM 111 + FLEX 13 + 02
(Group Number) +
[HOLD/SAVE]
VALUES --
Range 1-5
Release 3.5
June 2010
Page view 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 451 452

Comments to this Manuals

No comments