Vertical SBX IP 320 Service Manual download pdf (Page 52)

Call Handling 1-38

Chapter 1: Basic System Features

SBX IP Programming & Operations Guide

To use the Call Log feature:

1. Press the programmed {CALL LOG} button.

2. Use the up/down navigation buttons to scroll through the numbers to locate received

calls, dialed calls, and lost calls, as needed.

3. When the CLI of the appropriate number is displayed, press OK button.

The system will establish a call to that number.

4. Select the Lost Call Menu to view CLI MSG-Wait numbers.

A number in the Lost Call list can be answered, deleted, or saved by pressing the

Select soft button.

Call Screening

When a call is sent to a voice mailbox, the station associated with that mailbox can press a

pre-programmed button to listen to the caller leaving the voice mail message. If the mailbox

owner decides to speak with the caller, the owner can press the pre-programmed button to be

connected to the caller.

Notification Methods

Two methods of notification are available: Ring Mode or Speaker Mode. The pre-programmed

button type (Ring Mode or Spkr Mode) defines the operation mode.

EX. -- Station A user places their phone in the answering machine mode by pressing the

flexible button programmed on the telephone. The button light is solid red. When an

incoming CO call rings at a station and forwards (except busy type) to the station's voice

mailbox, the following will occur:

- In RING MODE, the preprogrammed answering machine flexible button flashes red

while the caller is in the owner's mailbox. The mailbox owner presses the

pre-programmed flashing button and the audio is broadcast over the speaker of the

keyset. The mute key is enabled on the keyset at this point. The LED light is solid

green.

- In SPKR MODE, the voice mail message is broadcast over the speaker. The mute key

is enabled on the keyset and the LED light is solid green.

CONDITIONS

• The user must have a digital Keyset.

• Keyset users must pre-program a CALL SCREENING flexible button.

• An idle station can press the flexible button to go to the inactive mode. The LED

extinguishes and No Answer calls are presented to the station.

• When button is programmed at the station, it is in the inactive mode (LED extinguishes).

Release 3.5

June 2010

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 451 452

No comments

Vertical SBX IP 320 Service Manual Page 52