Vertical SBX IP 320 Service Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 452
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Attendant Service 1-15
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
To change the time of a Day/Night Service mode:
Press PGM 233, then enter the times as needed.
NOTE: The default values of the Weekly Times are shown below. The first time settings
are for the Main Attendant (entry 00). Intercom Tenancy Group Attendants time
settings follow the Main Attendant (entry 01-15).
Outgoing Access
The Attendant can take a particular CO line out of service. If this occurs, outgoing CO cannot
be made while incoming CO calls are not affected.
CONDITIONS
Any Attendant can use this feature.
The LED of the CO line Flex button which is with an "out" setting, flashes at the Attendant
station, but is solidly lit at other stations.
If a specific CO line is busy, it can still be taken out of service. The change in setting will
take effect after the CO line returns to an idle state.
OPERATION / SETUP
To set the CO line outgoing service:
1. Press [TRANS/PGM], then press 073.
2. Press the appropriate CO line Flex button.
A confirmation tone will sound when the status of the selected CO line is changed.
3. Press [SPEAKER] to finish.
To release the"out" setting:
1. Press [TRANS/PGM], then press 073.
2. Press the flashing CO line Flex button at the Attendant station.
DATE DAY
START TIME
LUNCH
START TIME
LUNCH
END TIME
NIGHT
START TIME
WEEKEND
START TIME
Mon 09:00 -:- -:- 18:00 -:-
Tues 09:00 -:- -:- 18:00 -:-
Wed 09:00 -:- -:- 18:00 -:-
Thurs 09:00 -:- -:- 18:00 -:-
Fri 09:00 -:- -:- -:- 18:00
Sat -:- -:- -:- -:- 00:00
Sun -:- -:- -:- -:- 00:00
Release 3.5
June 2010
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 451 452

Comments to this Manuals

No comments