Other VOIB Programming Codes B-12
Appendix B: VoIP Service
SBX IP Programming & Operations Guide
RSG/IP Attributes (PGM 382)
Press the [TRANS/PGM] button, dial 382, and follow the specific procedure:
Transfer Mode -- determines Transfer mode
(IP address or MAC address) when using
RSG/IP phone; when using RSG/IP phone,
messages are sent to various devices using
an IP Address.
PGM 382 + FLEX 1 +
Value + HOLD/SAVE]
VALUES --
0 = IP (Default)
1 = MAC
Casting Mode -- determines Casting mode
(Uni-cast or Multi-cast) when using RSG/IP
phone.
PGM 382 + FLEX 2 +
Value + [HOLD/SAVE]
VALUES --
0 = UNI (Default)
1 = MULTI
Tone Source -- determines source for System
tones when using RSG/IP phone.
PGM 382 + FLEX 3 +
Value + [HOLD/SAVE]
VALUES --
0 = Off (Remote - Default)
RSGM/IP Phone
1 = On (SBX tone source)
Peer to Peer -- if value is set to ON, IP phone
to IP phone is connected directly. This means
that no VOIB channel is used for IP phone to
IP phone call case.
PGM 382 + FLEX 4 +
Value + [HOLD/SAVE]
VALUES --
0 = Off
1 = On (Default)
Codec Type -- determines Codec Type used
with RSG/IP phone.
PGM 382 + FLEX 5 +
Value + [HOLD/SAVE]
VALUES --
0 = G.711_ALAW (Default)
1 = G.711_ULAW
2 = G.723.1
3 = G.729
4 = G.729A
First Access RSG CO -- if set to ON, the
Station can access a CO line using the RSG
and dialing the CO Line access code in the 1st
available CO group (ex., 9).
PGM 382 + FLEX 6 +
Value + [HOLD/SAVE]
VALUES --
0 = Off
1 = On (Default)
Ring Without CO Ring Assign -- designates
the RSG Stations that will receive incoming
CO rings, even when CO ring is not assigned.
PGM 382 + FLEX 7 +
Value + [HOLD/SAVE]
VALUES --
0 = Off
1 = On (Default)
Comments to this Manuals